Radio frequency Packing machine Factory.Operating procedures for embossing machines

　　1. Turn on the power, close the heating switch on the switch board, and set the set value on the temperature setting instrument to the desired temperature. Set the pressure and time according to the requirements for processing leather.

　　2. When the temperature reaches the set temperature value, remove the start button of the oil pump motor, and wait for the oil pump motor to start and operate normally before processing leather.

　　3. Place the processed leather on top, press the safety door, lift the workbench, and apply pressure to the required pressure and time. Once the pressure is maintained, the workbench will automatically descend.

　　4. In case of emergency, the emergency stop device should be pressed.

　　5. Before starting work, carefully inspect the work board for any foreign objects.

　　6. Do not dismantle the safety door at will to prevent accidents.

　　7. If abnormal noise or overvoltage or overshoot is found in the machine, the maintenance personnel should be notified immediately for troubleshooting.

　　8. The hydraulic control valve on the machine must not be adjusted arbitrarily.

　　1. Purpose

　　To ensure the personal safety of operators and the safety of company property, this regulation is specially formulated.

　　2. Applicable scope

　　This regulation applies to the entire process of operation of the flat embossing machine operator in our company.

　　3. Job responsibilities

　　3.1 The Administrative Department is responsible for the compilation, review, and management of this regulation.

　　3.2 Operators must follow this procedure when operating the machine.

　　4. Safety operation requirements for operators

　　During operation, turn on the power, close the heating switch on the switch board, and set the set value on the temperature setting instrument to the desired temperature. At the same time, set the pressure and time according to the processing requirements.

　　When the temperature reaches the set temperature value, press the start button of the oil pump motor and wait for the oil pump motor to start and operate normally before proceeding.

　　4.3 Place the processed leather, press the safety door, and the workbench will rise and be pressurized to the required pressure and time. After the pressure is maintained, the workbench will automatically descend.

　　4.4 In case of emergency, the emergency stop device should be pressed.

　　Before starting work, carefully inspect the work board for any foreign objects.

　　4.6 Do not dismantle safety doors arbitrarily to prevent accidents from occurring

Read recommendations:

Ultrasonic welding machine for metal wire harness

Large vertical granule packaging machine

TPU embossing machine manufacturer

HF PET blister welding machine.What are the characteristics of ultrasonic slitting machine?

Slitting and cross-cutting machine