Automatic blister edge folding machine.What are the precautions when using an ultrasonic embossing machine

　　Regarding the basic knowledge of composite embossing machines, foot switches are vulnerable components; Variable amplitude rod of ultrasonic composite embossing machine; The ammeter reading exceeds 2A; The machine must be connected to the ground to ensure safety; The machine must be regularly maintained and serviced by a dedicated person; Do not open the cover of the ultrasonic vibrator unless absolutely necessary; When the ultrasonic generator is working; The continuous working time of the machine is 8 hours.

　　Common knowledge and new knowledge of embossing machine:

　　The above provides a brief introduction to the use and maintenance of ultrasonic embossing machines. Below is a brief introduction to the precautions when operating ultrasonic embossing machines.

　　1. When starting up, do not open the cover of the ultrasonic vibrator to avoid high pressure damage or damage to the machine.

　　2. The machine must be reliably grounded.

　　3. The output terminal of the ultrasonic generator must not be open circuited during operation.

　　4. When the ultrasonic generator is working, if the ammeter indicates more than 2A and there is insufficient power (the phenomenon is no trimming or perforation), it should be turned off immediately and the fault cause should be identified before starting up and working.

　　5. The continuous working time of the machine is 8 hours.

　　6. When the machine is not in use, loosen the pressure wheel, cut off the air source, and loosen the flower wheel.

　　7. The machine must be maintained and serviced by a dedicated person.

Read recommendations:

Stand alone vacuum skin packaging machine

Funny egg blister molding machine

Semi-automatic blister vacuum forming machine

Polyester welder equipment.Welding characteristics of ultrasonic embossing machine

Belt embossing machine