HF cutting machine supplier.Several troubleshooting methods for lace machines

　　Embossing machine (also known as "lace machine"), meaning the same, can be used to emboss, melt, weld, sew, or split fibers.

　　The advantages include no need for needle or thread, beautiful cutting edges, no water seepage, and less prone to edge peeling. Some inspection methods for the staff below the embossing machine (lace machine):

　　Method:

　　A. Use a meter to check if the vibration box has power supply.

　　B. Check if the protective wire has burned out. If it does, it indicates two issues:

　　C. If the vibrator is broken, take this set of vibrators to a normal vibration box for testing. The specific method is to use the third solution in the sequence to detect it;

　　D. First, open the development vibration box, check if the power amplifier board is burnt out, and then check if the vibration generator board is burnt out. The method is to replace the normal power amplifier board and vibration generator board with the faulty power amplifier board and vibration generator board for testing, and then replace them with a new fuse 5A.

　　Method:

　　A. When the adjustment cannot solve the problem, it is judged that the vibration component group and HORN are damaged.

　　B. Adjust the frequency modulation coil until both the current and amplitude are set to low points, and then adjust the amplitude to 1% higher than the original amplitude

Read recommendations:

Automatic high frequency slide table welding and cutting machine

Ice bag water bag high frequency welding plastic PVC TPU PET EVA molding machine

Ultrasonic plastic welding machine

HDPE Sheet Plastic Liners Welding Machine

RF Polyester welding machine supplier.How can machines improve production efficiency?