Operating Procedures for Ultrasonic Cutting Machine.TPU welding machine Production

　　1. According to the required cutting width and amplitude, install the prepared core on the winding shaft and place the winding shaft into the winding seat. After arranging the position of each roll in the middle, use a cone top. Press the downward button of the knife holder to press the pressure roller onto the surface of the winding roller.

　　2. Align the lower cutting blade so that its edge aligns with the seams of each core tube on the winding shaft, and then lock the lower blade. Adjust the upper and lower cutting axes to a depth of approximately 1.5mm. Bring the upper blade closer and clamp it evenly under pressure.

　　3. Thread the feeding shaft through the core of the raw material roll, so that the inclined roll is in the middle, and then tighten the cone tops at both ends and place them on the feeding rocker arm. Press the feeding button, the feeding roll will automatically enter the feeding seat, rotate the axial adjustment handwheel, and the seasoning roll will be in the middle of the machine.

　　4. Thread through the guiding substrate according to the process roadmap. When cutting, rotate the handwheel of the cutting shaft to pass the substrate through the cutting edge, and guide the cut banner end through the guide roller. The pressure roller is guided to the roll roller and pasted on the corresponding roll core (so that the pre tension of each banner is the same).

　　5. Before connecting the winding power, turn on the power source and let the machine air freight for 5 minutes. Check if there are any foreign objects in the running part of the machine and check the lubrication of all operating components

　　6. Turn the speed control motor controller button to, turn on the tension controller switch of the magnetic powder brake, set the tension value, then turn on the winding power, slowly and steadily increase the speed to a higher speed. As the diameter of the winding reel increases, gradually reduce the motor speed to ensure a constant cutting speed.

　　7. After the slitting of the coil is completed, disconnect the winding power and press the discharge button. The coil will be automatically and smoothly discharged to the ground by the hydraulic rocker arm.

　　8. Record the operation of equipment on duty and register the daily production volume.

　　9. Do a good job in environmental hygiene, fixed location management, and equipment cleanliness on duty.

　　10. Before leaving work, cut off the power switch

Read recommendations:

HF Blister packing machine custom

HF polymer welder maker

Positioning blister forming machine

The three main precautions of the roller.PVC bag solding machine

HF cutting machine Manufacturing.The New Technology of Embossing Machine