Radio frequency cutting machine Production.What is the testing method for ultrasonic laminating machines?

　　What is the testing method for ultrasonic laminating machines?

　　Before adjusting the vibration frequency between the generator and transducer system, as a user, it is necessary to ensure that the position between the welding head and the auxiliary rod of the ultrasonic lace machine is completely locked. After adjusting the vibration frequency, the applied welding head should not come into contact with other objects. If contact occurs, it needs to be wiped clean. Then, turn on the power switch of the ultrasonic lace machine. At this point, when the power guide light is on, it can indicate that it has been turned on. If you don't open it, you may want to loosen the links and adjust the requirements in real time. Otherwise, the machinery may malfunction and the following steps cannot be performed at this time.

　　If the guiding light is normal, you can press the switch for ultrasonic inspection. At this point, please pay attention to the load gauge. Generally speaking, when the pointer of the ammeter exceeds two amperes or 30%, the test switch will be pressed. This time is quite short, and the operators must conduct a thorough investigation. Then adjust the inductance of the vibration frequency one-sided, twist left and right, and reach the parameters of the ammeter, which is above the relatively small one-sided. Usually between 5% and 15% of the ammeter. Because the ultrasonic lace machine itself has a fixed clamping position, the adjustment limit is usually only between 360 degrees. If it is found that the frequency of the welding head is significantly different from the original parameters, it is necessary to open the top cover of the ultrasonic lace machine, remove it, and make new adjustments. If you are not a professional, you can seek sponsorship from manufacturers and do not damage the components of the ultrasonic lace machine casually.

　　In order to improve the manufacturing of ultrasonic lace machines, generally speaking, the gap between the welding head and the plastic parts should be as small as possible, but enough space should also be left for friends to take and place the plastic parts anytime and anywhere.

　　In the past two years, the demand for masks has been increasing, so many mask manufacturers have paid more attention to the work of ultrasonic lace machines. In order to improve the manufacturing process of ultrasonic lace machines, it is common to adjust the spacing between the welding head and the plastic parts to shorten the interval, but it is also necessary to leave a certain space for material retrieval and placement.

Read recommendations:

HF Polyester welder Manufacturing

HF embossing machine maker

HF resin welder maker

HF Blister packing machine wholesaler.Advantages and performance of the packaging belt of the embossing machine

TPU welding machine Factory.Introduction to dismantling clothing embossing machines