Single side feeding hydraulic cutting bed/cutter.What precautions should be taken when using an ultrasonic embossing machine

　　What precautions should be taken when using an ultrasonic embossing machine

　　Regarding the basic knowledge of ultrasonic embossing machines, the foot switch is a vulnerable component; The amplitude lever of the ultrasonic composite embossing machine; The ammeter reading exceeds 2A; The machine must be connected to the ground to ensure safety; The machine must be regularly maintained by dedicated personnel; Do not open the cover of the ultrasonic vibrator unless absolutely necessary; When the ultrasonic generator is working; The machine operates continuously for 8 hours.

　　New knowledge about embossing machines:

　　The above briefly introduces the use and maintenance of the ultrasonic embossing machine. Below is a brief introduction to the precautions when operating the ultrasonic embossing machine.

　　1. When starting up, do not open the cover of the ultrasonic vibrator to avoid high-voltage injury or damage to the machine.

　　2. The machine must be grounded reliably.

　　3. During the operation of the ultrasonic generator, it is strictly prohibited to open the output terminal.

　　4. When the ultrasonic generator is working, if the ammeter indicates more than 2A and there is insufficient power (such as no cutting or perforation), it should be immediately shut down. Only after identifying the cause of the fault can it be turned on for operation.

　　5. The machine operates continuously for 8 hours.

　　6. When the machine is not in use, loosen the pressure wheel, cut off the air source, and loosen the flower wheel.

　　7. The machine must be maintained by a dedicated person.

Read recommendations:

HF embossing machine price

1 M automatic disc high frequency welding machine

High Frequency Tarpaulin Tent Welding Machine

high frequency Membrane structure

EVA welding machine custom.Features of embossing machine products