Ultrasonic plastic toys welding machine.How to maintain the performance of ultrasonic composite machine

　　Due to the increasingly widespread application of ultrasonic cleaning equipment, various ultrasonic composite machines that have been continuously improved and perfected are replacing old equipment that has already been put on the market. Ultrasonic cleaning machines are developing in two directions. One is the successive launch of various types of multi cylinder or transmission chain or lifting ultrasonic cleaning production lines; The second is the development of low-frequency ultrasonic cleaning machines towards high-frequency ultrasonic cleaning machines.

　　Of course, there may be some common issues that arise during the use of ultrasonic composite machines. For example, if the ultrasonic vibrator is damp, a megohmmeter can be used to check the plug connected to the sensor. Checking the insulation resistance value can determine the basic situation, and generally requires the insulation resistance to be greater than 5 megohms. If the insulation resistance value cannot be reached, the sensor is generally damp. The sensor can be placed in an oven and dried at around 100 ℃ for 3 hours, or dried with a hair dryer until the resistance value is normal.

　　The sensor oscillator catches fire, the ceramic material breaks, and a combination of visual inspection and a megohmmeter is used for inspection. Generally, as an emergency measure, individual damaged oscillators can be cut off without affecting the normal use of other oscillators. The oscillator is detached, and our sensor adopts a dual guarantee technology of bonding and screw fastening, which generally does not occur. Stainless steel vibration surface perforation may occur after 10 years of full load use of sensors.

　　To avoid the above problems as much as possible, the power supply of the ultrasonic cleaning machine and the power supply of the electric heater must have good grounding devices. It is strictly prohibited to start without cleaning solution, that is, the cleaning cylinder must not be connected to the ultrasonic switch without adding a certain amount of cleaning solution; Cleaning equipment with heating devices is strictly prohibited from turning on the heating switch when there is no liquid.

Read recommendations:

high frequency embossing machine Production

HF embossing machine Processing

RF Blister packing machine manufacture

Why does the ultrasonic welding machine fail, what are the common failures, and how to deal with them?

Embossing Machine's installation and adjustment