HF embossing machine manufacturer.Do you understand the safety operating procedures for ultrasonic embossing machines

　　Do you understand the safety operating procedures for ultrasonic embossing machines? Friends who first came into contact with the ultrasonic embossing machine may feel somewhat constrained due to their unfamiliarity with this machine, which may affect the operation progress. Therefore, the safety operation regulations for the ultrasonic embossing machine are analyzed as follows:

　　The safety operating procedures for ultrasonic embossing machines are as follows:

　　1. According to the temperature specified in the production process, heat the embossed plate 30 minutes in advance. Check if the temperatures in the three temperature zones are the same.

　　2. Before starting work, Zui first checks the power switch that controls the lifting of the control console, and verifies whether the safety partition and emergency stop button are reasonable. When all automatic switches are not working, do not start the operation to prevent personal safety accidents!

　　3. Install the required embossed plates (or ironing plates) according to the production process regulations. Before installing the embossed plate (or ironing plate), all the embossed plates that are fixed to the fixed embossed plate (or ironing plate) should be removed, and there is no need to hang them on the foundation bolts to prevent damage to the embossed plate (or ironing plate). When replacing the wrench, the pressure cannot be adjusted too much.

　　4. When applying embossed boards, pay attention to the cleanliness and clarity of the pattern design. If there is environmental pollution, corresponding solvents and fine copper wire brushes should be used for painting. When there are standards, high-pressure water pumps and boiling water can be used for cleaning. When cleaning the flower board, remove it from the equipment and find a well ventilated area to eliminate open flames and combustibles.

　　5. Ensure safety during board replacement. During the operation of the elevator, notify other board changing personnel to ensure that all limbs of the personnel leave the operating platform and there are no other objects on the embossed board or ironing plate. Before applying an electric forklift, verify the working condition of the forklift. If there are any abnormalities, it is necessary to carry out maintenance to prevent accidental injury or damage to the embossed plate and ironing plate during the entire process of plate replacement.

Read recommendations:

RF Polyester welder equipment

RF embossing machine Processing

TPU embossing machine Vendor

Radio frequency cutting machine.Choose your own wireless sewing machine

RF Polyester welding machine supplier.How can machines improve production efficiency?