HF welding machine Vendor.The operation process of the embossing machine

　　1. The embossing equipment first connects to the three-phase power main switch, and then turns on the power switch on the machine side control box. If there is a high cycle switch, do not turn it on temporarily, and then turn on the electric heating power switch. At this point, the vacuum tube and hot mold begin to preheat.

　　2. Install insulation on the lower mold auxiliary, install the upper mold at the upper mold end, press the trial mold switch, and start debugging the joint position of the upper and lower molds. If the lower mold joint is not good, move the lower mold. If the levels are not consistent, adjust the four pillars of the upper mold.

　　3. After the adjustment of the high cycle plastic welding machine, adjust the three time controllers (if it is a pedal machine, only the high cycle welding time). The falling time is the upper mold compression time, and the welding time is the output time, cooling time, and curing time. The above three times should be used flexibly without fixed values.

　　If adjusting the model for the first time, it is necessary to adjust the spacing of the homology adjustment to be wide.

　　When the above operation lasts for more than 10-15 minutes and the temperature reaches the required level, turn on the high cycle switch and start the operation test.

Read recommendations:

Double Head Pedal HF Wedling and Cutting Machine Fabric Garment TPU sheet Tarpaulin PVC water proof bag

Automatic high frequency slide table welding and cutting machine

Hydraulic Automatic Die Cutting Press Machine

Maintenance of Roller Embossing Machines

Ultrasonic copper sheet welding machine.Small specialized embossing machine