TPU embossing machine wholesale.How to operate the leather embossing machine correctly?

　　As the name suggests, a leather embossing machine is a device for embossing clothing. So, how should we proceed with this? Meanwhile, what are its characteristics?

　　1. First, turn on the main switch of the three-phase power supply, and then turn on the power switch on the control box on the machine side. If there is a high cycle switch, do not turn it on temporarily. Then, turn on the electric heating power switch. At this point, the vacuum tube and the hot mold start to preheat.

　　2. Add insulation to the lower mold, install the upper mold at the upper end, press the mold test switch, and start debugging the joint position of the upper and lower molds. If the lower joint is poor, move the lower mold. If the level is not good, adjust the four pillars of the upper mold.

　　3. After the mold is adjusted, adjust the three time controllers (if it is a pedal type machine, only the high cycle welding time). The falling time is the time when the upper mold runs to press the lower mold, the welding time is the output time, and the cooling time is the curing time. The above three times need to be flexibly applied without fixed values.

　　4. If the mode is adjusted for the first time, it is necessary to adjust the spacing of the homologous tuning to the widest possible range.

　　5. If the above operation has exceeded 10-15 minutes and the temperature has reached the required level, turn on the high cycle switch and start the operation test.

　　Mainly using electronic heating controllers to heat the upper and lower templates, male and female molds are installed on the heating working plate, and a certain amount of pressure can be applied to fully achieve the purpose of embossing.

Read recommendations:

Automatic Up-Down Table HF Welding and Cutting Machine

Roll slitting machine

HF PETG welding and cutting machine

PVC fabric welding machine.Embossing machine installation operating rules

high frequency Solding machine Factory.Instructions for the use of ultrasonic flowers