What are the precautions when using an ultrasonic sofa cover embossing machine

　　Basic knowledge about ultrasonic sofa cover embossing machine, foot switch is a vulnerable part; The amplitude lever of the ultrasonic sofa embossing machine; The ammeter reading exceeds 2A; The machine must be connected to the ground to ensure safety; The machine must be regularly maintained and serviced by a dedicated person; Do not open the cover of the ultrasonic vibrator unless absolutely necessary; When the ultrasonic generator is working; The continuous working time of the machine is 8 hours.

　　Ultrasonic sofa cover embossing machine common knowledge new knowledge sofa cover embossing machine small knowledge:

　　The above briefly introduces the use and maintenance of the ultrasonic sofa cover embossing machine. Below is a brief introduction to the precautions when operating the ultrasonic sofa cover embossing machine.

　　1. When starting up, do not open the cover of the ultrasonic vibrator to avoid high pressure damage or damage to the machine.

　　2. The machine must be reliably grounded.

　　3. The output terminal of the ultrasonic generator must not be open circuited during operation.

　　4. When the ultrasonic generator is working, if the ammeter indicates more than 2A and there is insufficient power (the phenomenon is no trimming or perforation), it should be turned off immediately and the fault cause should be identified before starting up and working.

　　5. The continuous working time of the machine is 8 hours.

　　6. When the machine is not in use, loosen the pressure wheel, cut off the air source, and loosen the flower wheel.

　　7. The machine must be maintained and serviced by a dedicated person.

Read recommendations:

HF embossing machine

Single Head Round Table 3 Station HF Welding Machine

HF resin welder Processing

Protective suit hot air seam sealing machine

The Processing and Composite Technology of Fabric Composite Machine