frequency embossing machine company.Notes on embossing machine

　　1. According to the temperature requirements of the production process, heat the embossed board half an hour in advance. Check if the temperatures in the three temperature zones are consistent.

　　Before starting work, first check the various switches that control the rise of the workbench, and check whether the safety baffle and emergency stop switch are effective. When any control switch fails, do not start working to avoid personal injury accidents!

　　3. Install the required embossed boards (or ironing plates) according to the production process requirements. Before installing the boards, all the pressure plates that fix the embossed boards (or ironing plates) should be removed and not hung on bolts to avoid crushing the embossed boards (or ironing plates). The working pressure when changing the trigger cannot be adjusted too much.

　　4. When using embossed boards, attention should be paid to ensuring that the patterns are clean and clear. If there is pollution, corresponding organic solvents and fine copper wire brushes should be used for brushing. When conditions permit, high-pressure water guns and hot water can be used for flushing. When cleaning flower boards, they should be removed from the machine and found in a well ventilated place away from sources of fire and flammable materials.

　　5. During the board replacement process, attention should be paid to safety. Before lifting the workbench, other personnel involved in the board replacement work should be informed, and it should be confirmed that all personnel's limbs have left the workbench, and there are no other items on the embossed or ironed board. Before using a forklift, first check the working condition of the forklift. If there are any abnormalities, they must be repaired to avoid personal injury or damage to embossed boards and ironing plates during the board replacement process.

　　During the board replacement process, both the personnel who need to replace the board and the machine operator are present on site. During this process, be careful and avoid scratching the embossed board. After the board replacement is completed, when it is confirmed that there are no scratches on the embossed board during this board replacement process, the board replacement personnel and machine operators shall record the board replacement_ Sign on and specify the replacement time (accurate to minutes). If there are scratches, they should be reported in a timely manner. Those who conceal or do not report them will be held responsible for the replacement personnel and the previous use of this embossed board if they are found to have scratches by other operators before the next use.

　　7. No items other than leather sheets shall be placed on the workbench, except for felt mats and rubber sheets required for work.

　　8. When working, one should wear long sleeved work clothes with tight cufflinks or sleeves. Do not wear jewelry such as rings, bracelets, bracelets, etc. Nails should not be cut too short, and do not touch heated embossing boards or ironing plates. When using a mobile phone, leave the machine's working area.

Read recommendations:

HF Blister packing machine manufacture

Spring entry punching machine

RF Polyester welding machine equipment

PVC mesh welding machine.Factors in selecting the cleaning process for ordinary embossing machines

RF welding and cutting machine custom.Application scope of embossing machine